Cisco ONS 15454 Software Feature And Configuration Manual page 201

Appendix A Command Reference
[non] pos trigger defects condition
Use this command to specify which conditions cause the associated POS link state to change. These
conditions are soaked/cleared using the delay specified in the pos trigger delay command. Use the no
form of the command to disable triggering on a specific condition.
Syntax Description Parameter
condition
Defaults See list in above description.
Command Modes
Interface configuration mode (POS only)
Usage Guidelines This value is normally configured to match the setting on the peer PTE.
Examples
Gateway(config)# int pos0
Gateway(config-if)# pos trigger defects all
Related Commands pos trigger delay
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
78-15224-02
Description
The SONET/SDH condition that causes the link state change. The
conditions are as follows:
all—All link down alarm failures
ber_sd_b3—PBIP BER in excess of SD threshold failure
ber_sf_b3—PBIP BER in excess of SD threshold failure (default)
encap—Path Signal Label Encapsulation Mismatch failure (default)
pais—Path Alarm Indication Signal failure (default)
plop—Path Loss of Pointer failure (default)
ppdi—Path Payload Defect Indication failure (default)
pplm—Payload label mismatch path (default)
prdi—Path Remote Defect Indication failure (default)
ptim—Path Trace Indicator Mismatch failure (default)
puneq—Path Label Equivalent to Zero failure (default)
[non] pos trigger defects condition
A-5