DLP-G235 Change Card Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards
DLP-G235 Change Card Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Card settings can be changed only if the facilities are out-of-service (OOS).
Note
In node view, double-click the MXP_MR_2.5G or MXPP_MR_2.5G card where you want to change the
Step 1
card settings.
Click the Provisioning > Card tabs.
Step 2
Modify any of the settings described in
Step 3
Table 10-48 MXP_MR_2.5G and MXPP_MR_2.5G Muxponder Card Settings
Parameter
Card Mode
Wavelength
Step 4
Click Apply.
Return to your originating procedure (NTP).
Step 5
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-66
This task changes the card settings for MXP_MR_2.5G and
MXPP_MR_2.5G muxponder cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table
Description
Sets the mode of operation (option only
supported for SONET/SDH payloads).
Note: this setting is not currently
supported. The only option available
currently is FC-GE.
Sets the wavelength of the DWDM side
optical transmitter.
10-48.
Options
FC-GE
•
First Tunable Wavelength
•
Further wavelengths in 100-GHz ITU
•
spacing
Supported wavelengths are in white
•
and marked by asterisks (**);
unsupported wavelengths are gray.
The four available wavelengths
Note
are listed in the Card Parameters
section of the window.
Chapter 10
Change Card Settings
September 2004