Chapter 9
Manage the Node
•
•
Stop. You have completed this procedure.
DLP-G157 Disable Automatic Power Control
Purpose
Tools/Equipment
Prerequisite Procedures All procedures in
Required/As Needed
Onsite/Remote
Security Level
Disable APC only to perform specific troubleshooting or node provisioning tasks. Always enable APC
Caution
as soon as the tasks are completed. Leaving APC disabled can cause traffic loss.
Click the Maintenance > DWDM > APC tabs.
Step 1
Click Disable APC,
Step 2
On the confirmation dialog box, Click Yes.
Step 3
Return to your originating procedure.
Step 4
DLP-G158 Enable Automatic Power Control
Purpose
Tools/Equipment
Prerequisite Procedures All procedures in
Required/As Needed
Onsite/Remote
Security Level
Disable APC only to perform specific troubleshooting or node provisioning tasks. Always enable APC
Caution
as soon as the tasks are completed. Leaving APC disabled can cause traffic loss.
Click the Maintenance > DWDM > APC tabs.
Step 1
Click Enable APC.
Step 2
Step 3
On the confirmation dialog box, Click Yes.
September 2004
DLP-G158 Enable Automatic Power Control, page 9-5
DLP-G159 Refresh Automatic Power Control Information, page 9-6
This task disables the DWDM automatic power control (APC).
A node provisioning plan prepared by Cisco MetroPlanner is required.
As needed
Onsite or remote
Superuser
This procedure enables the DWDM automatic power control (APC).
A node provisioning plan prepared by Cisco MetroPlanner is required.
As needed
Onsite or remote
Superuser
Chapter 3, "Turn Up a Node."
Chapter 3, "Turn Up a Node."
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
DLP-G157 Disable Automatic Power Control
9-5