Dlp-G138 Refresh Pm Counts For A Different Port - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 8 Monitor Performance
In node view, double-click the card where you want to view PM counts. The card view appears.
Step 1
Click the Performance tab.
Step 2
From the Auto-refresh drop-down list, choose one of the following options:
Step 3
•
•
•
•
•
•
Click Refresh. The PM counts for the newly selected auto-refresh time interval appear.
Step 4
Depending on the selected auto-refresh interval, the displayed PM counts automatically update when
each refresh interval completes. If the auto-refresh interval is set to None, the PM counts that appear are
not updated unless you click Refresh.
Step 5 Return to your originating procedure (NTP).

DLP-G138 Refresh PM Counts for a Different Port

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the card where you want to view PM counts. The card view appears.
Step 1
Step 2 Click the Performance tab.
Step 3 In the Port drop-down list, choose a port.
Click Refresh. The PM counts for the newly selected port appear.
Step 4
Return to your originating procedure (NTP).
Step 5
September 2004
None: This option disables the auto-refresh feature.
15 Seconds: This option sets the window auto-refresh to 15-second time intervals.
30 Seconds: This option sets the window auto-refresh to 30-second time intervals.
1 Minute: This option sets the window auto-refresh to 1-minute time intervals.
3 Minutes: This option sets the window auto-refresh to 3-minute time intervals.
5 Minutes: This option sets the window auto-refresh to 5-minute time intervals.
This task changes the window view to display PM counts for another
port on a multiport card.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
DLP-G138 Refresh PM Counts for a Different Port
8-7