Dlp-G76 Provision Gcc Terminations - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G76 Provision GCC Terminations

Step 4 Click OK. Ports are automatically placed in service. Until all network OSC connections between nodes
are created and the ports are in service, the following alarms might appear:
•
•
Step 5 Return to your originating procedure (NTP).
DLP-G76 Provision GCC Terminations
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view click the Provisioning > Comm Channels > GCC tabs.
Step 1
In the GCC Terminations pane, click Create.
Step 2
Step 3 In the Create optical transport network (OTN) GCC Terminations dialog box, click the ports where you
want to create the GCC termination. To select more than one port, press the Shift key or the Ctrl key.
Note
(Optional) From the GCC Rate drop-down list, choose from two options:
Step 4
•
•
Click Set to IS if you want to put ports in service.
Step 5
If the SDCC termination is to include a non-ONS node, check the Far End is Foreign check box. This
Step 6
automatically sets the far-end node IP address to 0.0.0.0, which means that any address can be specified
by the far end. To change the default to a specific the IP address, see the
Termination" task on page
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
3-62
LOS-P (OSC termination failure)
Power failure alarms on the OPT-BST and/or OSC-CSM
Note After the OSC termination is created, the line ports are placed in service and span power
levels are checked. If power levels are low and/or the spans are not connected correctly, the
OSC termination alarms appear.
This task creates the DWDM GCC terminations required for network setup
when using the TXP_MR_10G, TXP_MR_2.5G, TXPP_MR_2.5G, and
MXP_2.5G_10G cards. Perform this task before you create circuits for
these cards. In this task, you can also set up the node so that it has direct
IP access to a far-end non-ONS node over the GCC network.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
GCC refers to the general communications channel, which is used for ONS 15454 transponders
and muxponders in DWDM applications.
192k is the line rate of Section DCC (SDCC)—This is the default option in Software R4.6.
576k is the line rate of Line DCC (LDCC)—This option will be supported in a future software
release.
9-28.
Chapter 3 Turn Up a Node
"DLP-G184 Change a GCC
September 2004