NTP-G96 Modify Line Settings and PM Parameter Thresholds for TXP_MR_10G and TXP_MR_10E Cards
NTP-G96 Modify Line Settings and PM Parameter Thresholds for
TXP_MR_10G and TXP_MR_10E Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
The TXP_MR_10G card does not support PPMs.
Step 1
Complete the
transponder card settings. If you are already logged in, proceed to
Step 2
Complete the
Step 3
Perform any of the following tasks as needed:
•
•
•
•
•
•
Step 4
Complete the
Stop. You have completed this procedure.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-32
This procedure changes the line and threshold settings for TXP_MR_10G
and TXP_MR_10E transponder cards.
None
NTP-G32 Install the Transponder and Muxponder Cards, page 3-30
DLP-G63 Install an SFP, page 3-32
NTP-G94 Provision Pluggable Port Modules, page
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
"NTP-G103 Back Up the Database" procedure on page
DLP-G216 Change Card Settings for TXP_MR_10G and TXP_MR_10E Cards, page 10-33
DLP-G217 Change Line Settings for TXP_MR_10G and TXP_MR_10E Cards, page 10-34
DLP-G219 Change Line Threshold Settings for TXP_MR_10G and TXP_MR_10E Cards, page
10-38
DLP-G220 Change Optical Thresholds Settings for TXP_MR_10G and TXP_MR_10E Cards, page
10-39
DLP-G218 Change Section Trace Settings for the TXP_MR_10G Card, page 10-37
DLP-G221 Change OTN Settings for TXP_MR_10G and TXP_MR_10E Cards, page 10-40
"NTP-G103 Back Up the Database" procedure on page
Chapter 10
Change Card Settings
10-29.
at the node where you want to change the
Step
2.
11-2.
11-2.
September 2004