Cisco ONS 15454 DWDM Installation And Operation Manual page 249

Chapter 4 Perform Node Acceptance Tests
Step 9 Verify the first channel connection configured in pass-through mode in both directions:
Set the tunable laser output power to a nominal values, such as –3 dBm, and tune it to the
a.
corresponding wavelength on the 100 GHz ITU-T grid.
b. Connect the tunable laser to the LINE RX port of the east OPT-BST using a 10 dB attenuator.
Step 10 Display the west 32WSS card in card view.
Click the Provisioning > Optical Chn > Parameters tabs.
Step 11
Change the Port 1 Admin State to OOS,MT (ANSI) or Locked,maintenance (ETSI).
Step 12
Change the Port 33 Admin State to OOS,MT (ANSI) or Locked,maintenance (ETSI).
Step 13
Click the Maintenance tab.
Step 14
For Channel #1, change Operating Mode to Pass Through.
Step 15
Repeat Steps
Step 16
Display the west 32WSS card in card view.
Step 17
Click the Provisioning > Optical Chn > Parameters tabs.
Step 18
Verify that the Port 33 power level reaches the provisioned VOA Power Ref setpoint.
Step 19
Repeat Steps
Step 20
Repeat Steps
Step 21
VOAs.
Display the west OPT-BST card (if present) in card view.
Step 22
Click the Provisioning > Optical Chn > Parameters tabs.
Step 23
Change the Port 1 Admin State to OOS,MT (ANSI) or Locked,maintenance (ETSI).
Step 24
Repeat Steps
Step 25
Display the west OPT-PRE card in card view.
Step 26
Click the Provisioning > Optical Chn > Parameters tabs.
Step 27
Step 28 Change the Port 6 Admin State to OOS,MT (ANSI) or Locked,maintenance (ETSI).
Step 29 Repeat Steps
If an OPT-BST card is installed on the west, complete the
Step 30
Laser and Power" task on page 4-22
Step 31 Repeat
Step 32 Complete the
OPT-PRE to ensure that the amplifier is working properly.
Tune the tunable laser to the first wavelength of the 100 GHz grid and connect it to the CHAN RX 30.3
Step 33
port on the west 32WSS card.
Display the west 32-WSS in card view.
Step 34
Click the Maintenance tab.
Step 35
For Channel #1, change Operating Mode to Add Drop.
Step 36
Step 37 Click the Provisioning > Optical Chn > Parameters tabs.
Step 38 Verify that the Port 1 power value reaches the provisioned VOA Power Ref setpoint.
Display the 32DMX card in card view.
Step 39
Click the Provisioning > Optical Chn > Parameters tabs.
Step 40
September 2004
11 through 15 for the east 32WSS card.
17 through 19 for the east 32WSS card.
9 through 20 for the remaining 32 wavelengths of the 100 GHz grid to verify all 32WSS
22 through 24 for the east OPT-BST card.
26 through 28 for the east OPT-PRE card.
30 for the east OPT-BST.
"DLP-G80 Verify the OPT-PRE Amplifier Laser and Power" task on page 4-23
NTP-G43 Perform the ROADM Node Acceptance Test
"DLP-G79 Verify the OPT-BST Amplifier
OPT-BST to ensure that the amplifier is working properly.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
on the west
4-7