Ntp-G90 Modify Line Settings And Pm Parameter Thresholds For Optical Service Channel Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G90 Modify Line Settings and PM Parameter Thresholds for Optical Service Channel Cards

8.
9.
10.
11.
12.
13.
NTP-G90 Modify Line Settings and PM Parameter Thresholds for
Optical Service Channel Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
OSCM or OSC-CSM card settings. If you are already logged in, proceed to
Complete the
Step 2
Perform any of the following tasks as needed:
Step 3
•
•
•
•
•
Complete the
Step 4
Stop. You have completed this procedure.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-2
NTP-G97 Modify Line Settings and PM Parameter Thresholds for MXP_2.5G_10G and
MXP_2.5G_10E Cards, page
threshold settings for MXP_2.5G_10G and MXP_2.5G_10E muxponder cards.
NTP-G98 Modify Line Settings and PM Parameter Thresholds for TXP_MR_2.5G and
TXPP_MR_2.5G Cards, page
threshold settings for TXP_MR_2.5G and TXPP_MR_2.5G transponder cards.
NTP-G99 Modify Line Settings and PM Parameter Thresholds for MXP_MR_2.5G and
MXPP_MR_2.5G Cards, page
threshold settings for MXP_MR_2.5G and MXPP_MR_2.5G muxponder cards.
NTP-G100 Modify Alarm Interface Controller Settings (ANSI Only), page
complete this procedure to change settings for external alarms, controls, and orderwire for the AIC
card.
NTP-G101 Modify Alarm Interface Controller–International Settings, page
complete this procedure to change settings for external alarms, controls, and orderwire for the AIC-I
card.
NTP-G102 Change Card Service State, page
card service state.
This procedure changes the line and threshold settings for optical service
channel cards (OSCM and OSC-CSM).
None
NTP-G30 Install the DWDM Cards, page 3-26
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
"NTP-G103 Back Up the Database" procedure on page
DLP-G199 Change Optical Line Settings for OSCM and OSC-CSM Cards, page 10-3
DLP-G200 Change Line Threshold Settings for OSCM and OSC-CSM Cards, page 10-5
DLP-G201 Change Optical Line Parameters for OSCM and OSC-CSM Cards, page 10-6
DLP-G202 Change Optical Channel Threshold Settings for OSCM and OSC-CSM Cards, page 10-8
DLP-G203 Change Maintenance Settings for Automatic Laser Shutdown, page 10-9
"NTP-G103 Back Up the Database" procedure on page
10-43—As needed, complete this procedure to change line and
10-55—As needed, complete this procedure to change line and
10-65—As needed, complete this procedure to change line and
10-83—As needed, complete this procedure to change
Chapter 10 Change Card Settings
10-77—As needed,
10-80—As needed,
at the node where you want to change the
Step 2.
11-2.
11-2.
September 2004