Advertisement
Remove and Replace a Line Card
Step 1
Unfasten the Velcro tapes holding the fibers to the fiber management bracket and free up space to remove the required
pluggable.
Step 2
If you want to remove the CIM8 module, then loosen the two screws, else continue with the next step.
Step 3
Use the pull tabs to pull out the required pluggable.
Step 4
Remove the fibers from the required pluggable.
Step 5
Repeat the previous steps until you complete removing all the required pluggables.
Step 6
(Optional) Insert pluggable caps into the pluggable slots when the slots have no pluggable.
What to do next
Install the Pluggables
Remove and Replace a Line Card
Use this procedure to remove and replace the line card or filler card in the Cisco NCS 1014 chassis.
Caution
Step 1
Using the T-15 six lobe/slot screwdriver, loosen the captive screws available in the line card.
Step 2
Holding the fiber management bracket with one hand and supporting the line card with the other, pull it from the slot.
Use the fiber management brackets only for pulling out or pushing in the line cards or filler cards. Do not
Caution
use the fiber management brackets to carry the cards. Always support the line card or filler card at the bottom
with your hand.
What to do next
Install the Line Card
Remove and Replace the Power Supply Unit (PSU)
Use this procedure to remove and replace a PSU in the Cisco NCS 1014 chassis.
Before you begin
Remove the connections to the power supply:
• Disconnect power from the breaker before disconnecting power from the power supply unit.
Remove and Replace Cisco NCS 1014 Modules
2
Perform the removal and replacement procedure for a line card or filler card only when the ambient temperature
is below 30℃ (80℉). Complete the procedure within five minutes to prevent overheating of the chassis
components.
Remove and Replace Cisco NCS 1014 Modules
Advertisement
