Compressor Clutch Overhaul - Honda Civic 2002-2003 Service Manual

~
Compressor Clutch Overhaul
Special Tool Required
Ne
clutch holder, Robinair 10204, Kent-Moore J37872,
or Honda Tool and Equipment KMT-J33939,
commercially available
1. Remove the center nut (A) while holding the
armature plate with a commercially available
Ne
clutch holder (8).
17.6N·m
11.8 kgf.m,
13lbf·ftl
2. Remove the armature plate (A) and shim(s)
(8),
taking care not to lose the shim(s). If the clutch
needs adjustment, increase or decrease the
number and thickness of shims as necessary, then
reinstall the armature plate, and recheck its
clearance (see page 21-48).
NOTE: The shims are available in four thicknesses:
0.1 mm, 0.2 mm, 0.4 mm, and 0.5 mm.
~~~
A
O--~---B
3. If you are replacing the field coil, remove the snap
ring (A) with snap ring pliers, then remove the rotor
pulley (B). Be careful not to damage the rotor pulley
or the compressor.
4. Remove the bolt and holder (A), then disconnect
the field coil connector (B). Loosen the clamp screw
(e)
to free the field coil wire. Remove the snap ring
(D) with snap ring pliers, then remove the field coil
(E). Be careful not to damage the field coil or the
compressor.
o
E
(cont'dl
21-49