Honda Civic 2002-2003 Service Manual page 1068

•
Il
16. Disconnectthe driver's airbag connector (see step
2 on page 23-21), front passenger's airbag
connector (see step 3 on page 23-21), and driver's
seat belt tensioner connector (see step 5 on page
23-22).
17. Disconnect SRS unit connector A (lap) from the
SRS unit (see step 7 on page 23-22).
la. Disconnect the special tool from dashboard wire
harness B.
19. Check resistance between the No.9 terminal and
the No. la terminal of SRS unit connector A (lap).
There should be an open circuit, or at least I M
Q.
SRS UNIT CONNECTOR A IISP)
RED/YEL
RED/BLK
Wire side of female terminals
Is the resistance as specified?
YES-Faulty SRS unit; replace the SRS unit (see
page 23-122) .•
NO-Short in dashboard wire harness B; replace
dashboard wire harness B .•
Dle 4-4:
Short to Power in Front Passenger's
Seat Belt Tensioner
Special Tools Required
• SRS inflator simulator 07SAZ-TB401 lA
• SRS simulator lead C 07TAZ-SZ5011A
• SRS simulator lead F 07XAZ-SZ30100
1. Erase the DTC memory (see page 23-26).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-26).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes .
4. Disconnectthe front passenger's seat belt
tensioner 2P connector (A) from the floor wire
harness.
5. Connect the SRS inflator simulator (2
Q
connector)
and simulator lead C to the floor wire harness.
(conl'd)
23-61