Component Replacement/Inspection After Deployment - Honda Civic 2002-2003 Service Manual

SRS
Component Replacement/Inspection After Deployment
NOTE: Before doing any SRS repairs, use the PGM
Tester SRS menu method to check for DTCs; refer to the
DTC Troubleshooting Index for the less obvious
deployed parts Iseat belt tensioners, front sensors, side
airbag sensors, etc.)
After a collision where the seat belt tensioners
deployed, replace these items:
• Seat belt tensioners
• Seat belt buckle tensioners
• SRS unit
• Front impact senSOrs
After a collision where the front airbagls) deployed,
replace these items:
• SRS unit
• Deployed airbagls)
• Seat belt tensioners
• Seat belt buckle tensioners
• Front impact sensors
After a collision where the side airbag(s) deployed,
replace these items:
• SRS unit
• Deployed side airbagls)
• Side impact sensor(s) for the side(s) that deployed
During the repair process, inspectthese areas:
• Inspect all the SRS wire harnesses. Replace, don't
repair, any damaged harnesses.
Inspect the cable reel for heat damage. If there is any
damage, replace the cable reel.
Afterthe vehicle is completely repaired, turn the
ignition switch ON III). If the SRS indicator comes on for
about 6 seconds and then goes off, the SRS airbag
system is OK. If the indicator does not function properly,
use the PGM Tester SRS Menu Method to read the DTC
Isee page 23-23). If this doesn't retrieve any codes, use
the Tester's SCS menu method (see page 23-24). If you
still cannot retrieve a code, go to SRS Indicator Circuit
Troubleshooting.
23-112