Knuckle Replacement - Honda Civic 2002-2003 Service Manual

Rear Suspension
Hub Bearing Unit Replacement
(cont'd)
9. Remove
the hub bearing unit (A) from the spindle.
10. Install the hub bearing unit in the
reverse
order of
removal, and note these items:
• Tighten all mounting hardware to the specified
torque values.
• Before installing the brake disc, clean the mating
surface of the hub and the inside of the brake
disc.
• Use a new spindle nut on reassembly.
• After tightening, use a drift to stake the spindle
nut shoulder against the spindle.
Use a new hub cap on reassembly.
Before installing the wheel. clean the mating
surface of the brake disc and the inside of the
wheel.
18-28
Knuckle Replacement
1.
Rai~e
the rear of the vehicle, and support it with
safety stands in the proper location (see page 1-8).
Remove the rear wheels.
2. Remove
the brake disc and hub bearing unit (see
step 1 on page 18-27).
3. Remove the flange bolts (A) and splash guard (B)
from the knuckle.
""
.... ' 1 11>
4. Remove the wheel sensor (Ai. brake hose
mounting bracket (B), and parking cable mounting
bracket
(e)
from the knuckle. Do not disconnect the
wheel sensor connector.
8x 1.25mm
22N·m
12.2 kgf.m, 161bf·1t1
6x 1.0mm
9.8N·m
(1.0 kgf·m, 7.2 Ibf·ItJ
B
,
•