Cisco ONS 15454 Reference Manual page 467

Chapter 13 Management Network Connectivity
13.7.10 Provisioning OSI in CTC
Table 13-18
Cisco ONS 15454 Procedure Guide for OSI procedures and tasks.
Table 13-18
Tab
OSI > Main Setup
OSI > TARP > Config
OSI > TARP > Static TDC
OSI > TARP > MAT
OSI > Routers > Setup
OSI > Routers > Subnets
OSI > Tunnels
Comm Channels > SDCC
Comm Channels > LDCC
Table 13-19
Table 13-19
Tab
OSI > ISIS RIB
OSI > ESIS RIB
OSI > TDC
OL-9217-01
shows the OSI actions that are performed from the node view Provisioning tab. Refer to the
OSI Actions from the CTC Provisioning Tab
Actions
View and edit Primary Area Address.
•
Change OSI routing mode.
•
Change LSP buffers.
•
Configure the TARP parameters:
PDU L1/L2 propagation and origination.
•
TARP data cache and loop detection buffer.
•
LAN storm suppression.
•
Type 4 PDU on startup.
•
TARP timers: LDB, T1, T2, T3, T4.
•
Add and delete static TARP data cache entries.
Add and delete static manual area table entries.
Enable and disable routers.
•
Add, delete, and edit manual area addresses.
•
Edit SDCC, LDCC, and LAN subnets that are provisioned for OSI.
Add, delete, and edit Cisco and IP-over-CLNS tunnels.
• Add OSI configuration to an SDCC.
Choose the data link layer protocol, PPP or LAP-D.
•
Add OSI configuration to an SDCC.
•
shows the OSI actions that are performed from the node view Maintenance tab.
OSI Actions from the CTC Maintenance Tab
Actions
View the IS-IS routing table.
View ESs that are attached to ISs.
View the TARP data cache and identify static and dynamic entries.
•
Perform TID to NSAP resolutions.
•
Flush the TDC.
•
13.7 13.7.10 Provisioning OSI in CTC
Cisco ONS 15454 Reference Manual, R7.0.1
13-63