Ce-1000-4 Card-Level Indicators - Cisco ONS 15454 Reference Manual

5.12 5.12.1 CE-1000-4 Card-Level Indicators

Figure 5-11
CE-1000-4
FAIL
ACT
Rx
1
Tx
ACT/LNK
Rx
2
Tx
ACT/LNK
Rx
3
Tx
ACT/LNK
Rx
4
Tx
ACT/LNK
5.12.1 CE-1000-4 Card-Level Indicators
The CE-1000-4 card faceplate has two card-level LED indicators, described in
Table 5-23
Card-Level LEDs
FAIL LED (Red)
ACT LED (Green)
Note If the CE-1000-4 card is inserted in a slot that has been preprovisioned for a different type of card, the
red FAIL LED and the green ACT LED will flash alternately until the configuration mismatch is
resolved.
Cisco ONS 15454 Reference Manual, R7.0.1
5-30
CE-1000-4 Faceplate and Block Diagram
SERDES
GBIC
SERDES
GBIC
4 ports:
GigE
SERDES
GBIC
SERDES
GBIC
CE-1000-4 Card-Level Indicators
Description
The red FAIL LED indicates that the card processor is not ready or that a
catastrophic software failure occurred on the CE-1000-4 card. As part of the
boot sequence, the FAIL LED is turned on until the software deems the card
operational.
The green ACT LED provides the operational status of the CE-1000-4 card.
When the ACT LED is green, it indicates that the CE-1000-4 card is active
and the software is operational.
8260 Processor, SDRAM
Flash and DecodePLD
TADM
Malena FPGA
Altera
CDR
Framer
BUFFER
MEMORY
Quicksilver
FPGA
CLOCK Generation
50MHz,100Mhz
5V, 3.3V, 2.5V, 1.8V, -1.7V
125Mhz,155MHz
Chapter 5 Ethernet Cards
Protect
RX BPIA
Protect
TX BPIA
BTC
BACKPLANE
192
Main RX
BPIA
Main TX
BPIA
Diff.
Delay.
Mem.
POWER
-48V
Table 5-23.
STS48
Interface
OL-9217-01