G1000-4 Card - Cisco ONS 15454 Reference Manual

Hide thumbs Also See for ONS 15454:

Table of Contents

5.6 5.6 G1000-4 Card

5.6 G1000-4 Card

The G1000-4 card requires the XC10G card. The ONS 15454 uses G1000-4 cards for Gigabit Ethernet

(1000 Mbps). The G1000-4 card provides four ports of IEEE-compliant, 1000-Mbps interfaces. Each

port supports full-duplex operation for a maximum bandwidth of OC-48 on each card.

The G1000-4 card uses GBIC modular receptacles for the optical interfaces. For details, see the

"5.13 Ethernet Card GBICs and SFPs" section on page

Any new features that are available as part of this software release are not enabled for this card.

Figure 5-5 shows the card faceplate and the block diagram of the card.

The G1000-4 Gigabit Ethernet card provides high-throughput, low latency transport of Ethernet

encapsulated traffic (IP and other Layer 2 or Layer 3 protocols) across a SONET network. Carrier-class

Ethernet transport is achieved by hitless (< 50 ms) performance in the event of any failures or protection

Cisco ONS 15454 Reference Manual, R7.0.1

G1000-4 Faceplate and Block Diagram

To FPGA, BTC,

Ethernet Cards