Ml1000-2 Card-Level Indicators - Cisco ONS 15454 Reference Manual
Hide thumbs
Also See for ONS 15454:
- Procedure manual (850 pages) ,
- Troubleshooting manual (558 pages) ,
- Software feature and configuration manual (232 pages)
Table of Contents
Advertisement
Chapter 5
Ethernet Cards
5.10.1 ML1000-2 Card-Level Indicators
The ML1000-2 card faceplate has two card-level LED indicators, described in
Table 5-19
Card-Level LEDs
SF LED (Red)
ACT LED (Green)
5.10.2 ML1000-2 Port-Level Indicators
The ML1000-2 card has three LEDs for each of the two Gigabit Ethernet ports, described in
Table 5-20
Port-Level Indicators
ACT LED (Amber)
LINK LED (Green)
Both ACT and LINK LED
5.10.3 Cross-Connect and Slot Compatibility
The ML1000-2 card is compatible in Slots 1 to 6 or 12 to 17 with the XC10G or XC-VXC-10G card. It
is only compatible in Slots 5, 6, 12, or 13 with the XCVT card.
5.11 CE-100T-8 Card
Note
For hardware specifications, see the
The CE-100T-8 card provides eight RJ-45 10/100 Mbps Ethernet ports and an RJ-45 console port on the
card faceplate. The CE-100T-8 card provides mapping of 10/100 Mbps Ethernet traffic into SONET
STS-12 payloads, making use of low-order (VT1.5) virtual concatenation, high-order (STS-1) virtual
concatenation, generic framing procedure (GFP), and point-to-point protocol/high-level data link
control (PPP/HDLC) framing protocols.
OL-9217-01
ML1000-2 Card-Level Indicators
Description
The red FAIL LED indicates that the card processor is not ready or that a
catastrophic software failure occurred on the ML1000-2 card. As part of the
boot sequence, the FAIL LED is turned on until the software deems the card
operational.
The green ACT LED provides the operational status of the ML1000-2. When
the ACT LED is green, it indicates that the ML1000-2 card is active and the
software is operational.
ML1000-2 Port-Level Indicators
Description
A steady amber LED indicates a link is detected, but there is an issue
inhibiting traffic. A blinking amber LED means traffic flowing.
A steady green LED indicates that a link is detected, but there is no
traffic. A blinking green LED flashes at a rate proportional to the level
of traffic being received and transmitted over the port.
Unlit green and amber LEDs indicate no traffic.
"A.7.6 CE-100T-8 Card Specifications" section on page
5.11 5.10.1 ML1000-2 Card-Level Indicators
Table
Cisco ONS 15454 Reference Manual, R7.0.1
5-19.
Table
5-20.
A-47.
5-25
Advertisement
Table of Contents
