Oc192 Ir/Stm64 Sh 1550 Card-Level Indicators - Cisco ONS 15454 Reference Manual

Chapter 4 Optical Cards
Table 4-16
Card-Level LED
Red FAIL LED
ACT/STBY LED
Green (Active)
Amber (Standby)
Amber SF LED
4.15.2 OC192 IR/STM64 SH 1550 Port-Level Indicators
You can find the status of the OC192 IR/STM64 SH 1550 card ports by using the LCD screen on the
ONS 15454 fan-tray assembly. Use the LCD to view the status of any port or card slot; the screen
displays the number and severity of alarms for a given port or slot. Refer to the Cisco ONS 15454
Troubleshooting Guide for a complete description of the alarm messages.
4.16 OC192 LR/STM64 LH 1550 Card
For hardware specifications, see the
Note
on page
Any new features that are available as part of this software release are not enabled for this card.
Note
The OC192 LR/STM64 LH 1550 card provides one long-range SONET/SDH OC-192 port compliant
with ITU-T G.707, ITU-T G.691, ITU-T G.957, and Telcordia GR-253-CORE (except minimum and
maximum transmit power, and minimum receive power). The card port operates at 9.95328 Gbps over
unamplified distances up to 80 km (50 miles) with different types of fiber such as C-SMF or dispersion
compensated fiber limited by loss and/or dispersion. The card supports VT, nonconcatenated (STS-1),
or concatenated payloads.
There are two versions of the OC192 LR/STM64 LH 1550. The earliest version has the product ID
15454-OC192LR1550, and the latest card's product ID is 15454-OC192-LR2. These cards have slight
specification differences that are noted throughout this description.
You can differentiate this OC-192/STM-64 card (15454-OC192-LR2, 15454E-L64.2-1) from the
Note
OC-192/STM-64 card with the product ID 15454-OC192LR1550 by looking at the faceplate. This card
does not have a laser on/off switch.
OL-9217-01

OC192 IR/STM64 SH 1550 Card-Level Indicators

Description
The red FAIL LED indicates that the card's processor is not ready. This LED
is on during reset. The FAIL LED flashes during the boot process. Replace
the card if the red FAIL LED persists.
If the ACT/STBY LED is green, the card is operational and ready to carry
traffic. If the ACT/STBY LED is amber, the card is operational and in
standby (protect) mode or is part of an active ring switch (BLSR).
The amber SF LED indicates a signal failure or condition such as LOS, LOF,
or high BERs on one or more of the card's ports. The amber SF LED is also
on if the transmit and receive fibers are incorrectly connected. If the fibers
are properly connected and the link is working, the light turns off.
A-39. See Table 4-2 on page 4-4
4.16 4.15.2 OC192 IR/STM64 SH 1550 Port-Level Indicators
"A.6.15 OC192 LR/STM64 LH 1550 Card Specifications" section
for optical card compatibility.
Cisco ONS 15454 Reference Manual, R7.0.1
4-33