Xc10G Card; Table 2-15 Xcvt Card-Level Indicators - Cisco ONS 15454 Reference Manual

2.5 2.5 XC10G Card

Table 2-15
Card-Level Indicators
Red FAIL LED
ACT/STBY LED
Green (Active)
Amber (Standby)
2.5 XC10G Card
For hardware specifications, see the
Note
The 10 Gigabit Cross Connect (XC10G) card establishes connections at the STS-1 and VT levels. The
XC10G provides STS-192 capacity to Slots 5, 6, 12, and 13, and STS-48 capacity to Slots 1 to 4 and 14
to 17. The XC10G allows up to four times the bandwidth of the XCVT cards. The XC10G provides a
maximum of 576 STS-1 cross-connections through 1152 STS-1 ports. Any STS-1 on any port can be
connected to any other port, meaning that the STS cross-connections are nonblocking.
Figure 2-5
Cisco ONS 15454 Reference Manual, R7.0.1
2-18
XCVT Card-Level Indicators
Definition
Indicates that the cards processor is not ready. Replace the card if the red
FAIL LED persists.
Indicates whether the XCVT card is active and carrying traffic (green) or in
standby mode to the active XCVT card (amber).
"A.4.4 XC10G Card Specifications" section on page
shows the XC10G faceplate and block diagram.
Chapter 2 Common Control Cards
A-12.
OL-9217-01