1-Port Oc-192C/Stm-64 Pos/Rpr Vsr Optics Spa Interface Specifications - Cisco Catalyst 6500 Series Hardware Installation Manual

Chapter 3 Catalyst 6500 Series Switch SPA Overview
Table 3-19
Table 3-19 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA LEDs
LED Label
WRAP
PASSTHRU
MATESYNC
CARRIER
ACTIVE
STATUS

1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Interface Specifications

The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA contains a SONET/SDH framer to process
incoming and outgoing SONET or SDH frames. The framer operates at OC-192/STM-64 line rates (9.95
Gbps).
Packet data is transported with a user-configured encapsulation (such as Point-to-Point Protocol [PPP])
and is mapped into the STS-192c/STM-64 frame.
The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA interface is compliant with the following
RFCs:
•
•
OL-9041-04
describes the 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA LEDs.
Color State
Off Off
Green On
Amber On
Off Off
Amber On
Off Off
Green On
Off Off
Green On
Amber On
Blinking
Off Off
Green On
Amber On
Off Off
Green On
Amber On
RFC 1662, PPP in HDLC-like Framing
RFC 2615, PPP over SONET/SDH
1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Overview
Meaning
Port is not in wrap mode.
Port is in wrap mode somewhere on the ring.
Port is in wrap mode locally.
Port is not in pass-through mode.
Port is in pass-through mode.
Mate port is not synchronized.
Mate port is synchronized.
Port is not enabled by software.
Port is enabled by software, and there is a valid SONET signal
without alarms.
Port is enabled by software, and there is at least one alarm
(LOS, LOF, RDI, and so on).
SRP mode mismatch alarm is indicated.
Port is not enabled by software.
Port is enabled by software, and loopback is off.
Port is enabled by software, and loopback is on.
SPA power off.
SPA is ready and operational.
SPA power is on and good, and the SPA is being configured.
Catalyst 6500 Series Switch SIP, SSC, and SPA Hardware Installation Guide
3-37