1-Port Oc-192C/Stm-64 Pos/Rpr Xfp Spa Leds - Cisco Catalyst 6500 Series Hardware Installation Manual

1-Port OC-192c/STM-64 POS/RPR XFP SPA Overview

1-Port OC-192c/STM-64 POS/RPR XFP SPA LEDs

The 1-Port OC-192c/STM-64 POS/RPR XFP SPA has six LEDs, as shown in
Figure 3-25
1
2
3
The WRAP, PASSTHRU, and MATESYNC LEDs apply to the SPA in RPR/SRP mode only. Support for
Note
the RPR/SRP feature is dependent on the platform software release feature content. Verify support for
the RPR/SRP feature using SPA datasheets or by contacting your Cisco representative.
Table 3-17
Table 3-17
LED Label
WRAP
PASSTHRU
MATESYNC
CARRIER
Catalyst 6500 Series Switch SIP, SSC, and SPA Hardware Installation Guide
3-32
1-Port OC-192c/STM-64 POS/RPR XFP SPA Faceplate
1 3
2
WRAP LED
PASSTHRU LED
MATESYNC LED
describes the 1-Port OC-192c/STM-64 POS/RPR XFP SPA LEDs.
1-Port OC-192c/STM-64 POS/RPR XFP SPA LEDs
Color State
Off Off
Green On
Amber On
Off Off
Amber On
Off Off
Green On
Off Off
Green On
Amber On
Blinking SRP mode mismatch alarm is indicated.
Chapter 3
4
5
4 CARRIER LED
5 ACTIVE LED
6 STATUS LED
Meaning
Port is not in wrap mode.
Port is in wrap mode somewhere on the ring.
Port is in wrap mode locally.
Port is not in pass-thru mode.
Port is in pass-thru mode.
Mate port is not synchronized.
Mate port is synchronized.
Port is not enabled by software.
Port is enabled by software, and there is a valid SONET signal
without alarms.
Port is enabled by software, and there is at least one alarm (LOS,
LOF, RDI, and so on).
Catalyst 6500 Series Switch SPA Overview
Figure 3-25.
SPA-0C192POS-XFP
6
OL-9041-04