Cable and Port Specifications
This section includes the cables and connectors used with the Cisco MDS 9396V Multilayer Fabric Switch.
Caution
•
•
•
•
Cables and Adapters
The Cisco MDS 9396V Switch accessory kit includes the following:
• RJ-45 to RJ-45 rollover cable
• RJ-45 to DB-9 female DTE adapter (labeled "Terminal")
• RJ-45 to DB-25 female DTE adapter (labeled "Terminal")
• RJ-45 to DB-25 male DCE adapter (labeled "Modem")
Note
Note
We strongly recommend that power cable runs and other potential noise sources be located as far away as
practical from network cabling that terminates on Cisco equipment. In situations where long parallel cable
runs exist but cannot be separated by at least 3.3 ft. (1 m), we recommend that you shield these potential noise
sources. To avoid interference, the source should be shielded by housing it in a grounded metallic conduit.
Cables and Adapters, on page 45
Console Port, on page 46
MGMT 10/100/1000 Ethernet Port, on page 47
Supported AC Power Cords and Plugs, on page 49
Additional cables and adapters can be ordered from your customer service representative.
If you purchased this product through a Cisco reseller, contact the reseller directly for technical support. If
you purchased this product directly from Cisco, contact Cisco Technical Support at this URL:
http://www.cisco.com/c/en/us/support/index.html.
C H A P T E R
Cisco MDS 9396V Multilayer Fabric Switch Hardware Installation Guide
7
45