Deactivation Of A Sip Configuration Example; Activation Of A Sip Configuration Example - Cisco Catalyst 6500 Series Hardware Installation Manual

Chapter 5 Installing and Removing a SIP or SSC

Deactivation of a SIP Configuration Example

Deactivate a SIP when you want to perform OIR of the SIP. The following example deactivates the SIP
that is installed in slot 5 of the switch, its SPAs, and all of the interfaces. The corresponding console
messages are shown:
Router# configure terminal
Router(config)# no power enable module 5
1w4d: %OIR-6-REMCARD: Card removed from slot 5, interfaces disabled
1w4d: %C6KPWR-SP-4-DISABLED: power to module in slot 5 set off (admin request)

Activation of a SIP Configuration Example

Activate a SIP if you have previously deactivated it. If you did not deactivate the SPAs, the SPAs
automatically reactivate with reactivation of the SIP.
OL-9041-04
Catalyst 6500 Series Switch SIP, SSC, and SPA Hardware Installation Guide
Online Insertion and Removal
5-7