Required Tools And Equipment; Safety Guidelines - Cisco Catalyst 6500 Series Hardware Installation Manual

Preparing to Install a SIP, SSC, or SPA
This chapter describes the general equipment, safety, and site preparation requirements for installing
SIPs, SSCs, and SPAs. This chapter contains the following sections:
•
•
•

Required Tools and Equipment

You need the following tools and parts to install SIPs and SPAs. If you need additional equipment,
contact a service representative for ordering information.
•
•
•
•
•
•
•
•
•

Safety Guidelines

This section provides safety guidelines that you should follow when working with any equipment that
connects to electrical power or telephone wiring. This section contains the following topics:
•
•
•
•
OL-9041-04
Required Tools and Equipment, page 4-1
Safety Guidelines, page 4-1
Laser/LED Safety, page 4-3
Shared port adapter interface processor (SIP)
Shared port adapter (SPA)
SPA Services Card (SSC)
Number 1 Phillips and a 3/16-inch flat-blade screwdriver
Number 2 Phillips screwdriver
Torque screwdriver with range from 8 to 12 inch-pounds (90 to 135 Newton-centimeters)
Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist
strap supplied with the SIP or SPA
Antistatic mat
Antistatic container
Safety Warnings, page 4-2
Electrical Equipment Guidelines, page 4-2
Telephone Wiring Guidelines, page 4-2
Preventing Electrostatic Discharge Damage, page 4-3
C H A P T E R
Catalyst 6500 Series Switch SIP, SSC, and SPA Hardware Installation Guide
4
4-1