Mate Interface Cables - Cisco Catalyst 6500 Series Hardware Installation Manual

Chapter 3 Catalyst 6500 Series Switch SPA Overview
Table 3-18 OC-192 Specifications (continued)
Specification
RX Overload
Maximum Receiver Power Damage

Mate Interface Cables

The 1-Port OC-192c/STM-64 POS/RPR XFP SPA supports two mate interface configurations:
•
•
Two 1-Port OC-192c/STM-64 POS/RPR XFP SPAs are connected using a 40–pin connector copper mate
cable. The length of the cables allow only two possible connection scenarios, next slot horizontal and
same slot vertical. This assumes that the chassis is mounted vertically.
used to connect the SPAs.
Figure 3-27
1
Note The RPR mate cable is only necessary when the SPA is to be used in RPR mode. It is not needed in POS
mode. Support for the RPR feature is dependent on the platform software release feature content. Verify
support for the RPR feature using SPA datasheets or by contacting your Cisco representative.
OL-9041-04
Mate between two OC-192c SPAs in the same SIP
Mate between two OC-192c SPAs in adjacent SIPs
SPA Mate Cables
Long length RPR mate cable for single port
RPR SPAs (CBL-RPR-OC192-L)
Description
OC-192 SR-1: –1 dBm
OC-192 IR-2: +2 dBm
OC-192 LR-2: –7.0 dBm
OC-192 SR-1: +5 dBm
OC-192 IR-2: +5 dBm
OC-192 LR-2: +5 dBm
1
2
2 Short length RPR mate cable for single port
RPR SPAs (CAB-RPR-OC192-S)
Catalyst 6500 Series Switch SIP, SSC, and SPA Hardware Installation Guide
1-Port OC-192c/STM-64 POS/RPR XFP SPA Overview
Figure 3-27 shows the mate cables
3-35