Appendix A Cable And Port Specifications; Cables And Adapters - Cisco MDS 9148V-K9 Hardware Installation Manual

Cable and Port Specifications
This appendix includes information about the cables and connectors used with the Cisco MDS 9148T Multilayer
Fabric Switch.
Caution
•
•
•
•

Cables and Adapters

The Accessory kit includes the following:
• RJ-45-to-RJ-45 rollover cable
• RJ-45-to-DB-9 female DTE adapter (labeled Terminal)
• RJ-45-to-DB-25 female DTE adapter (labeled Terminal)
• RJ-45-to-DB-25 male DCE adapter (labeled Modem)
Note
Note
We strongly recommend that power cable runs and other potential noise sources be located as far away as
practical from network cabling that terminates at Cisco equipment. In situations where long parallel cable
runs exist, but cannot be separated by at least 3.3 ft. (1 m), we recommend that you shield these potential
noise sources. To avoid interference, the source should be shielded by housing it in a grounded metallic
conduit.
Cables and Adapters, on page 49
Console Port, on page 50
Out of Band Ethernet Management Port, on page 51
Supported Power Cords and Plugs, on page 53
Additional cables and adapters can be ordered from your customer service representative.
If you purchased this product through a Cisco reseller, contact the reseller directly for technical support. If
you purchased this product directly from Cisco, contact Cisco Technical Support at
http://www.cisco.com/c/en/us/support/index.html.
A P P E N D I X
Cisco MDS 9148V-K9 Switch Hardware Installation Guide
A
49