1-Port Oc-192C/Stm-64 Pos/Rpr Spa Interface Specifications - Cisco Catalyst 6500 Series Hardware Installation Manual

Chapter 3 Catalyst 6500 Series Switch SPA Overview
Table 3-16 1-Port OC-192c/STM-64 POS/RPR SPA LEDs (continued)
LED Label
ACTIVE
STATUS

1-Port OC-192c/STM-64 POS/RPR SPA Interface Specifications

The 1-Port OC-192c/STM-64 POS/RPR SPA contains a SONET/SDH framer to process incoming and
outgoing SONET or SDH frames. The framer operates at OC-192/STM-64 line rates (9.95 Gbps).
Packet data is transported with a user-configured encapsulation (such as Point-to-Point Protocol [PPP])
and is mapped into the STS-192c/STM-64 frame.
The 1-Port OC-192c/STM-64 POS/RPR SPA interface is compliant with the following RFCs:
•
•
•
The 1-Port OC-192c/STM-64 POS/RPR SPA also provides support for SNMP v1 agent
(RFC 1155–1157) and RFC 1213:
•
•
•
•
1-Port OC-192c/STM-64 POS/RPR SPA Fixed Optical Transceiver, 40-Pin
Connector, and Cables
The 1-Port OC-192c/STM-64 POS/RPR SPA uses fixed optical transceivers, one for receive (RX) and
one for transmit (TX), for SONET and SDH connection to the network. In Cisco IOS Release 12.0(31)S,
only long-reach (LR) optics are supported.
Cisco Systems qualifies the optics that are approved for use with its SPAs. Check the product overview
section of this guide to determine which optical transceiver modules are qualified for use.
OL-9041-04
Color State
Green On
Amber On
Blinking
Off Off
Green On
Amber On
Off Off
Green On
Amber On
RFC 1619, PPP over SONET/SDH
RFC 1662, PPP in HDLC-like Framing
RFC 2615, PPP over SONET/SDH
RFC 1155, Structure and Identification of Management Information for TCP/IP-Based Internets
RFC 1156, Management Information Base for Network Management of TCP/IP-Based Internets
RFC 1157, Simple Network Management Protocol (SNMP)
RFC 1213, Management Information Base (MIB) for Network Management of TCP/IP-Based
Internets:MIB II
Meaning
Port is enabled by software; there is a valid SONET signal
without alarms.
Port is enabled by software; there is at least one alarm (LOS,
LOF, RDI, and so on).
Indicates SRP mode mismatch alarm.
Port is not enabled by software.
Port is enabled by software; loopback is off.
Port is enabled by software; loopback is on.
SPA power off.
SPA is ready and operational.
SPA power is on and good; SPA is being configured.
Catalyst 6500 Series Switch SIP, SSC, and SPA Hardware Installation Guide
1-Port OC-192c/STM-64 POS/RPR SPA Overview
3-29