Cable And Port Specifications; Cables And Adapters - Cisco MDS 9000 Series Hardware Installation Manual

Cable and Port Specifications

This appendix includes information about the cables and connectors used with this switch.
Caution
•
•
•
•

Cables and Adapters

The accessory kit includes the following:
• RJ-45-to-RJ-45 rollover cable
• RJ-45-to-DB-9 female DTE adapter (labeled Terminal)
• RJ-45-to-DB-25 female DTE adapter (labeled Terminal)
• RJ-45-to-DB-25 male DCE adapter (labeled Modem)
Note
Note
We strongly recommend that power cable runs and other potential noise sources be located as far away
as practical from network cabling that terminates at Cisco equipment. In situations where long parallel
cable runs exist, but cannot be separated by at least 3.3 ft. (1 m), we recommend that you shield these
potential noise sources. To avoid interference, the source should be shielded by housing it in a grounded
metallic conduit.
Cables and Adapters, on page 47
Console Port, on page 48
Out of Band Ethernet Management Port, on page 49
Supported Power Cords and Plugs, on page 51
Additional cables and adapters can be ordered from your customer service representative.
If you purchased this product through a Cisco reseller, contact the reseller directly for technical support.
If you purchased this product directly from Cisco, contact Cisco Technical Support at
http://www.cisco.com/c/en/us/support/index.html.
A P P E N D I X
Cisco MDS 9124V-K9 Switch Hardware Installation Guide
A
47