Oc-192 Module Connections - Cisco Catalyst 6500 Series Hardware Installation Manual

1-Port OC-192c/STM-64 POS/RPR XFP SPA Overview
Figure 3-26
OC-192c/STM-64 POS/RPR XFP SPA.
Figure 3-26
The 40-pin connector on the 1-Port OC-192c/STM-64 POS/RPR XFP SPA is used for resilient packet
Note
ring (RPR) connections. Support for the RPR feature is dependent on the platform software release
feature content. Verify support for the RPR feature using SPA datasheets or by contacting your Cisco
representative.

OC-192 Module Connections

Table 3-18
SPA.
Table 3-18 OC-192 Specifications
Specification
Wavelength
Cabling distance (maximum)
Operating case temperature range
Tx Power
Receiver Sensitivity (maximum)
Catalyst 6500 Series Switch SIP, SSC, and SPA Hardware Installation Guide
3-34
shows the cable type for use with the XFP optical transceiver module on the 1-Port
LC-Type Cable for the XFP Optical Transceiver Modules
RX TX
shows the OC-192 specifications for use with the 1-Port OC-192c/STM-64 POS/RPR XFP
Chapter 3
/ /
/ / / /
Description
OC-192 SR-1: 1290 nm to 1330 nm
OC-192 IR-2: 1530 nm to 1565 nm
OC-192 LR-2: 1530 nm to 1565 nm
OC-192 SR-1: 2 km (1.2 miles)
OC-192 IR-2: 40 km (24.8 miles)
OC-192 LR-2: 50 miles (80 km)
OC-192 SR-1: 23 to 158 degrees F (–5 to 70 degrees C)
OC-192 IR-2: 23 to 158 degrees F (–5 to 70 degrees C)
OC-192 LR-2: 23 to 158 degrees F (–5 to 70 degrees C)
OC-192 SR-1: –6 dBm –1 dBm
OC-192 IR-2: –1 dBm +2 dBm
OC-192 LR-2: 0 to +4 dBm
OC-192 SR-1: –11 dBm
OC-192 IR-2: –14 dBm
OC-192 LR-2: –24 dBm
Catalyst 6500 Series Switch SPA Overview
OL-9041-04