Specifying The Sip Or Ssc Subslot Location For A Spa - Cisco Catalyst 6500 Series Hardware Installation Manual

Cisco 7600 SIP-200 Overview

Specifying the SIP or SSC Subslot Location for a SPA

SIP subslots begin their numbering with 0 and have a horizontal or vertical orientation depending on the
orientation of the SIP in the router chassis slot, as shown in the "SIP, SSC, and SPA Product Overview"
chapter of the Catalyst 6500 Series Switch SIP, SSC, and SPA Software Configuration Guide.
Figure 2-1
Cisco 7609 router. The Cisco 7600 SIP-200 supports four subslots for the installation of SPAs. In this
example, the subslot locations are oriented vertically as follows:
•
•
•
•
Figure 2-2
Figure 2-2
7600-SIP-200
SPA INTERFACE
PROCESSOR
In this view, the subslot locations in a horizontal orientation are as follows:
•
•
•
•
The SIP subslot numbering is indicated by a small numeric label beside the subslot on the faceplate.
Some commands, such as the show idprom module and show hw-module subslot commands, allow
you to display information about the SPA itself. These commands require you to specify both the
physical location of the SIP and SPA in the format slot/subslot.
•
•
For example, to display the operational status for the SPA installed in the first subslot of the SIP in
chassis slot 6 shown in
Router# show hw-module subslot 6/0 oir
For more information about SIP commands, refer to the
References.
Cisco 7600 SIP-200 Overview
The following sections describe the 7600-SIP-200:
•
Catalyst 6500 Series Switch SIP, SSC, and SPA Hardware Installation Guide
2-4
shows an example of a Cisco 7600 SIP-200 installed with a vertical orientation on a
SIP subslot 0—Top–right subslot
SIP subslot 1—Bottom–right subslot
SIP subslot 2—Top–left subslot
SIP subslot 3—Bottom–left subslot
shows the faceplate for the Cisco 7600 SIP-200 in a horizontal orientation.
Cisco 7600 SIP-200 Faceplate
SIP subslot 0—Top–left subslot
SIP subslot 1—Top–right subslot
SIP subslot 2—Bottom–left subslot
SIP subslot 3—Bottom–right subslot
slot—Specifies the chassis slot number in the Catalyst 6500 Series switch where the SIP is installed.
subslot—Specifies the secondary slot of the SIP where the SPA is installed.
Figure
Cisco 7600 SIP-200 Processor, page 2-5
Chapter 2
2-1, enter the following command:
Cisco IOS Software Releases 12.2SX Command
Catalyst 6500 Series Switch SIPs and SSCs Overview
OL-9041-04