Canon WUX6000 User Manual page 161

2
Select [B-width], and use the remote's [ ] [ ] buttons to specify the width
of area B.
This will make the width of area D narrower.
3
Adjust the width of area B to roughly match the area where the black level
is noticeable, and then use the following edge-blending settings to adjust
the black level of area B.
Adjust the black level of area B the same way as you adjusted it for area D.
Black level
B-area base
B-area red
B-area green Adjust the green component of the area B black level.
B-area blue
For adjustment instructions, see "Advanced Instructions: Black Level
Adjustment" (P158), step 3.
Results of adjusting the black level of area B are applied to all sides.
4
Fine-tune the position and width of area B.
5
As you watch the image, adjust the width of areas A, B, and C.
6
Readjust the black level of area B, as needed.
7
When you have completed the adjustment, press the MENU button.
• [Off] is the factory default.
• To reduce distracting colors and colors that are out of alignment in areas where the images
overlap, perform [Color blending adjustment] targeting the main tone in the envisaged
projected image.
If you perform adjustments using [Color blending adjustment] or other menus, that may
not eliminate the distracting colors and differences in brightness in areas where the
images overlap.
Downloaded from ProjectorsManual.com Manuals
Installation-Related Menu Settings
Adjust the area B black level.
Adjust the red component of the area B black level.
Adjust the blue component of the area B black level.
161