Installing / Removing The Lens Unit; Installing The Lens Unit - Canon WUX6000 User Manual

Installation Procedure

Installing / Removing the Lens Unit

■ Installing the Lens Unit

Before installing or removing the lens unit, be sure to disconnect the
power plug or connector. Failure to do so may result in fire, electric
shock, or injury.
• Before replacing the lens unit, make sure to turn off the projector,
• Do not touch the lens when the lens is moving (the lens is shifting) to
• When hanging the projector from a ceiling, put the projector down
• Do not attempt to install or remove the lens unit yourself. Be sure to
• When installing and removing the lens unit, be sure not to touch the
• Do not apply force to parts (e.g. lead wires) that are connected to the
• Do not replace the lens unit in a dusty location. If any dust or dirt
• For details about which devices the projector is compatible with,
1
Use a Phillips-head screwdriver and loosen the lamp cover screw, then
open the lamp cover.
The lamp cover screw is attached to the lamp cover and designed to prevent it
from falling off.
Downloaded from ProjectorsManual.com Manuals
wait at least 1 hour to allow the projector to cool thoroughly. Failure
to do so may result in burns or other injuries.
adjust the projected image after installation. There is the risk of
injury.
on the floor or a workbench before attaching or replacing the lens
unit. Failure to do so could result in parts falling off the projector and
may cause an accident or personal injury.
request this service from a qualified technician or contact the Canon
Customer Support Center.
surface of the lens with your hands or scratch it.
lens unit or lens motor. Doing so may cause a malfunction.
enters the projector, this may adversely affect picture quality.
contact the Canon Customer Support Center.
Screw
120