Canon WUX6000 User Manual page 133

• Use a DVI-D-sub 15 cable in which all pins are connected. If the cable is a type in which
all pins are not connected, the image may not be correctly displayed.
• Use an audio cable without a built-in resistor. Using an audio cable with a built-in
resistor will reduce the audio volume.
• The AUDIO IN terminal can be changed in the Audio in terminal select screen (P106).
Connecting with a BNC cable (Input signal type: [Analog PC-2] P39)
Computer
Monitor output terminal
(Mini D-sub 15-pin)
AUDIO output terminal
(AUDIO OUT)
• A signal with a dot clock higher than 162 MHz cannot be projected.
• Use an audio cable without a built-in resistor. Using an audio cable with a built-in
resistor will reduce the audio volume.
• The AUDIO IN terminal can be changed in the Audio in terminal select screen (P106).
■ Connecting to DVI Monitor Output Terminal (Digital
Connection)
Connecting with a DVI cable (Input signal type: [Digital PC] P39)
Computer
Monitor output terminal
(DVI terminal)
AUDIO output terminal
(AUDIO OUT)
Downloaded from ProjectorsManual.com Manuals
Mini D-sub 15-pin - Mini D-sub 15-pin -
BNC terminal BNC terminal
converter cable converter cable
(not included) (not included)
BNC cable (not included)
When inputting corresponding audio
Audio cable (not included)
DVI cable (not included)
When inputting corresponding audio
Audio cable (not included)
Connection Procedure
COMPONENT terminal
To AUDIO IN terminal 2
To ANALOG PC-1 / DVI-I terminal
To AUDIO IN terminal 1
133
Projector
To ANALOG PC-2 /
Projector