Assigning A Channel For Remote Control - Canon WUX6000 User Manual

Customizing System Operation (System Settings)
Assigning a Channel
for Remote Control
> [System settings] >
control channel]
HDMI
Digital PC
When using multiple projectors at
the same time (maximum 4), you can
assign a different channel to each
remote control so that each operates
independently.
Selecting the Projector Channel
Ch1 Select the remote control
Ch2 channel to use with this
Ch3 projector.
Ch4
Independent Remote controls set to any
channel can be used.
Press the OK button to accept your
setting and then press the MENU
button.
• The factory default is [Independent] for both
projector and remote control.
• After changing the channel on the menu, be
sure to change the channel of the remote
control too.
• If an optional wired remote control (RS-
RC05) is used, there is no need to set the
remote control channel.
Downloaded from ProjectorsManual.com Manuals
[Remote
Component LAN
Analog PC USB
Selecting a Channel on the
Remote control
You can change the channel on the
remote control as follows.
Ch1 Press and hold the OK
button and [ ] button at the
same time for 3 seconds.
Ch2 Press and hold the OK
button and [ ] button at the
same time for 3 seconds.
Ch3 Press and hold the OK
button and [ ] button at the
same time for 3 seconds.
Ch4 Press and hold the OK
button and [ ] button at the
same time for 3 seconds.
Independent Press and hold the OK
button and
same time for 3 seconds.
102
button at the