NEC Univerge SV9100 Hardware Manual page 374

Issue 1.2
5 - 114
21. Reinstall the legs, pushing upwards until both locks snap into
place.
22. Set tilt legs to desired position.
23. Return the multiline terminal to the numbered keypad in the up
position.
24. Connect the Line cord and the AC adapter.
25. Place the Bluetooth handset in the cradle.
Before you use the handset for the first time or reuse the handset after
.
it has been left out of service for a long time, charge it for at least five
hours. A full charge takes approximately 16 hours.
26. Erect the antenna (refer to
Installed).
Figure 5-129 Bluetooth Handset Installed
Installing DT Series Digital and IP Multiline Terminals
UNIVERGE SV9100
Figure 5-129 Bluetooth Handset