Chs Large Batt Box Fuse Replacement; Power Supply; Remove And Install Cooling Fan; Chs2Ug Chassis - NEC Univerge SV9100 Hardware Manual

UNIVERGE SV9100
P
S 7
OWER
ECTION
R
S 8
EMOVE AND
ECTION
If required, the cooling fan installed in the CHS2UG chassis can be removed and
replaced. Follow the procedure below for the CHS2UG chassis.
8.1
System Hardware Manual
Figure 3-111 CHSG LARGE BATT BOX to CHS2UG Connection
6. Reconnect AC power cable to rear of 9.5" chassis.
7. To power on the 9.5" chassis, refer to Chapter 4,
SV9100 on page
6.4.3

CHS LARGE BATT BOX Fuse Replacement

To replace the fuse(s) in the CHS LARGE BATT BOX, refer to Chapter 3,
section 6.2.4 CHS LARGE BATT BOX Fuse Replacement on page
S
UPPLY
Do not attempt to replace the power supply on the CHS2UG chassis. The
MPS7101 is not a field replaceable part. If the power supply fails, contact
NEC.
I
NSTALL

CHS2UG Chassis

4-9.
C F
OOLING AN
Issue 1.2
2.6 Powering Up the
3-67.
3 - 79