Installation - NEC Univerge SV9100 Hardware Manual

Issue 1.2
4 - 20
 Call Control Server
 Conference Bridge Server
 Voice Mail Server (voice mail requires a compact flash card)
 SIP Server
 RTP Forwarding
VoCoder Conversion

3.1.2

Installation

Each SV9100 system must have the GCD-CP10 installed in Slot 1
of the Controlling Chassis.


1. Install the battery on the GCD-CP10. The polarity "+" symbol
must be on top as illustrated in
Installation.
IMPORTANT INSTALLATION NOTES
The chassis power must be off when installing or
removing the GCD-CP10.
After removing a previously installed
GCD-CP10, handle the blade, carefully, from the
edges. If certain solder points/resistors are
touched on the back of the blade, some RAM/
temporary memory may be lost (e.g., time, date,
user-defined settings, etc.)
Figure 4-5 GCD-CP10 Battery Installation
UNIVERGE SV9100
Figure 4-5 GCD-CP10 Battery
Installing the SV9100 Blades