D-Link DCS-F Series User Manual page 89

Camera User Manual
Parameter
Limit Type
Output
Channel
Audible Alarm
Flashlight
Alarm
Alarm Record
SMTP
FTP Upload
Whitelight
Alarm
Step 3 Set a deployment area
Drawing a line: Move the cursor to the drawing interface, hold down the left mouse button, and move
the cursor to draw two lines. When you release the left mouse button, two numbered virtual fences are
generated. Choose either of the double line crossing to set the direction to Positive or Reverse.
Setting double line crossing: Click one of the double line crossing (and the virtual fence turns red) to
select this virtual fence and set the direction to Positive or Reverse, or delete the selected line. You can
Issue V1.0 (2023-02-10)
Description
Enable to choose the limit type (person or car /
person / car) from type drop-down list.
If you check to set the Output Channel and the
device is connected to an external alarm
indicator, the alarm indicator signals when an
alarm is triggered. Only for some models.
Enable, when the alarm happens, it will be play
audio to alarm.
Choose the audible alarm file (set at the
"Configuration > Alarm > Audible Alarm
Output").
Only for some models.
Enable to flashlight alarm when it triggers the
alarm, the flashlight will flash. Only for some
models.
Enable the button to enable the alarm record.
Enable the button to enable SMTP sever. For
more details, please refer to chapter 13.5
Enable the button to enable File Transfer
Protocol. For more details, please refer to
chapter 13.6 .
When the DayNight mode is chosen Night
mode, and the light is IR LED or NONE, this
linkage action is valid.
Enable to whitelight alarm when it triggers the
alarm, the whitelight will be on. Only for Some
Models.
Configure Intelligent Analysis
Setting
[How to set]
Click the button on.
[Default value]
OFF
[How to set]
Click to select an ID.
[How to set]
Click the button on.
[Default value]
OFF
[How to set]
Click the button on.
[Default value]
OFF
[How to set]
Click to enable Alarm
Record.
[Default value]
OFF
[How to set]
Click to enable
SMTP.
[Default value]
OFF
[How to set]
Click to enable FTP.
[Default value]
OFF
[How to set]
Click the button on.
[Default value]
OFF
81