Bosch JLR-100-069 Original Instructions Manual page 44

en-gb | 46 | JLR-100-069
6. There are two M5 screws on both the top and
bottom of each long side (33) on the scissors lift
table. Loosen all four M5 screws located at the
top of the long sides (33) and set them aside.
Figure 59: Opening the Protective Bellows
3 Platform (static)
4 Platform (extendible)
5 Protective Bellows
33 Long Side
34 Snaps (8 pieces per long side)
7. Undo the snaps (34).
8. Let the protective bellows (5) drop.
9. Reach through the handle (1) with a pair of
locking pliers. Place the locking pliers on the
collar shaft (41).
SP04006297 | 06/2021
Figure 60: Locking Block, Detailed View
17 Mechanical Lock (Notch)
18 Locking Block
38 Tooth
39 Anchor Spring
40 Spring
41 Collar Shaft
10. Pull on the collar shaft (41) with the locking
pliers until the locking block's (18) tooth (38)
moves up into the next notch of the mechanical
lock (17).
11. Press the end of the pedal marked "RELEASE" (9)
to lower the platforms (3) and (4) until the
locking block's (18) tooth (38) locks into the
notch of the mechanical lock (17).
12. Remove the locking pliers from the collar shaft
(41).
13. Remove the damaged spring (40) from the collar
shaft (41) and the anchor spring (39) and dispose
of it.
14. Insert one hook of the new spring (40) into the
eye of the anchor spring (39).
15. Push the other hook of the new spring (40) into
the notch in the collar shaft (41) until it locks into
place.
16. Press the end of the pedal marked "PUMP" (11)
to raise the platforms (3) and (4) just enough to
release the locking block's (18) tooth (38) from
the notch in the mechanical lock (17).
17. Press the lever (2) to release the mechanical lock
(17). Simultaneously press the end of the pedal
marked "RELEASE" (9) to lower the platforms (3)
and (4) a little.
Bosch Automotive Service Solutions GmbH
Am Dörrenhof 1
85131 Pollenfeld-Preith
Germany