Setting Up The Scissors Lift Table; Removing The Packaging - Bosch JLR-100-069 Original Instructions Manual

en-gb | 15 | JLR-100-069
3 Setting up the Scissors Lift
Table
NOTICE
Danger of Destroying the Pump!
If the platforms are raised before the pump has been
prepared, the pump could be destroyed.
Set up the scissors lift table only in the order
specified in this chapter.
The packaging also serves to remove the scissors lift
table from the pallet.
Dispose of packaging that is no longer needed in a
suitable location and in accordance with all
applicable regulations.
Figure 8: Scissors Lift Table on the Pallet
1 Handle
10 Pump
21 Cover/Ramp
22 Pallet
23 Wooden Pegs (4 pieces)
24 Wooden Strips (2 pieces)
SP04006297 | 06/2021
3.1

Removing the Packaging

1. Cut the straps on the carton with a knife, cutting
pliers, or scissors. Remove the straps from the
carton. Remove the carton from the pallet (22).
2. Cut the cable ties on the handle (1) with a knife,
cutting pliers, or scissors. Remove the cable ties
from the handle (1). Remove the handle (1) from
the pallet (22).
3. Remove the two spax screws from the cover (21).
Remove the cover (21) from the scissors lift
table. Position the pallet (22) so that the cover
(21) creates a ramp to the ground [on the side of
the pump (10)].
Figure 9: Attaching the Ramp to the Pallet
10 Pump
21 Cover/Ramp
22 Pallet
Bosch Automotive Service Solutions GmbH
Am Dörrenhof 1
85131 Pollenfeld-Preith
Germany