Bosch JLR-100-069 Original Instructions Manual page 21

en-gb | 23 | JLR-100-069
11. Connect the compressed-air supply to the
scissors lift table.
The compressed-air connection has a 1/4 inch
external thread.
Use clean and dry compressed air with a
pneumatic input pressure only up to 6 bar
(87.02 psi).
Figure 24: Connecting the Compressed-Air Supply
7 Bottom Frame
9 Pedal (end marked "RELEASE")
10 Pump
11 Pedal (end marked "PUMP")
12 Brake Pedal
15 Hydraulic Pressure Relief Valve
16 Compressed-Air Connection
19 Ball Valve
20 Manometer Connection
12. If necessary, unlock the padlock on the ball valve
(19). Twist the ball valve (19) until it is parallel to
the bottom frame (7) to release the platforms (3)
and (4).
13. If necessary, adjust the height of the platforms
(3) and (4).
Press the end of the pedal marked "PUMP" (11)
to raise the platforms (3) and (4).
Press the lever (2) to release the mechanical lock
(17). Simultaneously press the end of the pedal
marked "RELEASE" (9) to lower the platforms (3)
and (4).
The pedal may briefly vibrate when pressed. This
is normal and presents no danger.
SP04006297 | 06/2021
14. Twist the ball valve (19) until it is positioned 90°
to the bottom frame (7) to secure the platforms
(3) and (4). If necessary, secure the ball valve
(19) with the padlock.
WARNING
Danger of the Platforms Lowering
Unintentionally!
If the platforms are not secured and someone
presses the pedal, the platforms could be
lowered unintentionally. This could result in
serious personal injuries or severe damage to
materials.
Always secure the platforms with the ball valve.
Bosch Automotive Service Solutions GmbH
Am Dörrenhof 1
85131 Pollenfeld-Preith
Germany