Bosch JLR-100-069 Original Instructions Manual page 20

en-gb | 22 | JLR-100-069
8. Ensure that the platforms (3) and (4) are level on
the scissors lift table. If not, turn the spindles
(27) to tilt the platforms (3) and (4) until they are
level.
There are several ways to turn the spindles (27):
Turn the spindles (27) with a 3/8 inch wrench.
Turn the spindles (27) with an open-end or
combination wrench, wrench size 21.
Turn the spindles (27) with a cordless
screwdriver.
Figure 21: Straightening the Platforms
4 Platform (extendible)
27 Spindles (2 pieces)
9. If necessary, place the rubber mats on the
platforms (3) and (4). Secure the rubber mats to
the platforms (3) and (4) with the bushings (30)
in the threaded holes (31) on top of the platforms
(3) and (4).
SP04006297 | 06/2021
Figure 22: Platforms with Rubber Mats and Bushings
3 Platform (static) with Rubber Mat
4 Platform (extendible) with Rubber Mat
30 Bushings (10 pieces per set)
31 M10 Threaded Holes on Top of the Platforms
10. Insert the compressed-air hose through the
compressed-air hose clamp (8).
Figure 23: Attaching the Compressed-Air Hose to the
Scissors Lift Table
1 Handle
8 Compressed-Air Hose Clamp
9 Pedal (end marked "RELEASE")
10 Pump
11 Pedal (end marked "PUMP")
12 Brake Pedal
Bosch Automotive Service Solutions GmbH
Am Dörrenhof 1
85131 Pollenfeld-Preith
Germany