Locking Pin - Bosch JLR-100-069 Original Instructions Manual

en-gb | 39 | JLR-100-069
6.8

Locking Pin

The protective bellows need to be opened for certain
maintenance work and to replace certain parts on the
scissors lift table.
CAUTION
Crushing Hazard in the Scissors Element!
Hands or fingers could be crushed when raising or
lowering the platforms.
Open the protective bellows only when there are
no loads on the platforms.
Open the protective bellows only for the
maintenance work specified in these instructions.
Use the scissors lift table only with the protective
bellows in place.
Only qualified personnel may open the protective
bellows.
Keep hands and feet out of the scissors element.
Close the protective bellows after the maintenance
work has been completed.
CAUTION
Danger of Cuts!
Handling the platforms carelessly could result in
hands or fingers being cut.
Always wear safety gloves when handling the
platforms.
1. There are two M5 screws on both the top and
bottom of each long side (33) on the scissors lift
table. Loosen all four M5 screws located at the
top of the long sides (33) and set them aside.
SP04006297 | 06/2021
Figure 45: Opening the Protective Bellows
3 Platform (static)
4 Platform (extendible)
5 Protective Bellows
33 Long Side
34 Snaps (8 pieces per long side)
2. Undo the snaps (34).
3. Let the protective bellows (5) drop.
4. Loosen all six countersunk head screws (47) on
top of the static platform (3) and set them aside.
Figure 46: Platforms from above
3 Platform (static)
4 Platform (extendible)
47 Countersunk Head Screws M10 x 80 (6 pieces)
Bosch Automotive Service Solutions GmbH
Am Dörrenhof 1
85131 Pollenfeld-Preith
Germany