Operating Instructions - Bosch JLR-100-069 Original Instructions Manual

en-gb | 20 | JLR-100-069

4 Operating Instructions

1. Ensure that the scissors lift table is complete and
inspect it for visible damage, such as bends,
cracks, dents, or damage to threaded holes in the
platforms. Do not use the scissors lift table if
damaged or in poor condition, but take it out of
operation immediately and call the service hotline.
2. Ensure that the ground is level, sturdy, and free
of obstruction.
WARNING
Danger of the Scissors Lift Table Rolling on
Slopes and Ramps!
The scissors lift table could roll down slopes and
ramps by itself. The scissors lift table is heavy
and therefore has a longer braking distance.
Handling the scissors lift table on slopes and
ramps carelessly could cause serious personal
injuries or severe damage to materials.
Move the scissors lift table on ground that is
as even as possible. Do not move the scissors
lift table over slopes above 3.5°, with the
exception of the ramp included in delivery.
Move the scissors lift table in the direction of
the slope, not across it.
Personnel must remain above the scissors lift
table on slopes.
Use the scissors lift table only with the help of
an assistant to control its movements.
SP04006297 | 06/2021
3. If necessary, adjust the handle (1).
CAUTION
Danger of Personal Injuries when Moving the
Scissors Lift Table!
If the vehicle part protrudes beyond the edge of
the platforms, personal injuries could occur when
pushing or pulling the scissors lift table.
Adjust the handle so that the vehicle part does
not protrude beyond the handle and so that
there is enough room to use the handle to
move the scissors lift table.
Ensure that the path is clear and easily visible.
Remove the hexagon head screws (25) from the
handle (1) and set them aside.
Pull out or push in the handle (1) to the desired
position so that the holes in the bottom frame (7)
align with the holes in the handle (1).
Tighten all four hexagon head screws (25) in the
holes with a torque of 25 Nm.
Figure 18: Adjusting the Handle
1 Handle
7 Bottom Frame
25 Hexagon Head Screws M8 x 45 8.8 (4 pieces)
Bosch Automotive Service Solutions GmbH
Am Dörrenhof 1
85131 Pollenfeld-Preith
Germany