Table of Contents
Advertisement
OAM&P and IP Data 10/100Base T Ethernet Interfaces
Item/Parameter
Network data rate
Interface
Impedance
Cable
Output format
Connector
Application Protocols*
* IP data supports a subset of these protocols.
GigE Interface
Wavelengths are 850 nm, 1310 nm, and 1550 nm. Electrical GigE interface modules are
also supported using high-quality CAT-5e or CAT-6 cable.
SFP Specifications
The APEX1000 GigE interface requires SFP transceivers. Each of the four GbE interfaces
can accept any one of a variety of Small Form Factor Pluggable (SFP) modules, including
1000 Base SX (850 nm), 1000 Base LX (1310 nm), and 1000 Base ZX (1550 nm) fiber
based modules, or 1000 Base T Electrical based modules.
Note: The Gigabit Ethernet interfaces are full-duplex interfaces with respect to standard
L2/L3 Ethernet traffic. This includes ARP Responses to ARP Requests, ICMP Echo
Responses to ICMP Echo Requests, IGMP Joins, IGMP Host Membership Reports in
response to IGMP Queries, etc..
RF Interface
Parameter
QAM frequency range
Carrier frequency step size
Carrier frequency accuracy
Channel spacing
Annex B DC II 64 QAM
Appendix A • Specifications
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
Description
10/100 Mbps maximum
IEEE 802.3
120 Ohms
Shielded twisted pair
188 mode only
RJ 45
UDP, TCP/IP, ICMP, ARP, IGMP, SNMP, BOOTP, TFTP, SNTP, HTTP,
Auto negotiation full and half duplex modes
Specification
54 to 1003MHz
250 kHz
±5 ppm
1 to 8 MHz
Symbol Rate
5.056942 Msym/sec
B
283
Advertisement
Table of Contents
