All Operating
Modes
**An Active state implies that the RF module is installed, and the QAM channel is enabled. A Not
Active state here could be brought about by removing an RF module or disabling the QAM
channel.
Mapping Activation
The APEX1000 allows manual routing and UDP port mapping routings to be made to any
output QAM that is installed and enabled (entitled).
•
Activation of a mapping indicates that the mapping is attempted. The UDP port is
opened, multicast group is joined (if needed), PSI is extracted, and data is routed
through the APEX1000.
•
De-activation means that the mapping is stopped, but the actual database holding
the mapping remains. This allows you to remove an RF module and then plug it back
in, causing all manual routings and UDP port mappings to be immediately re-
activated.
Configuration • Output TS Configuration
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
QAM Channel
Not Active To
Not Active
Active State
•
You may not
Activate Mappings.
create or edit
mappings.
•
You may delete
existing
mappings.
•
You may NOT
edit QAM
channel settings.
QAM Channel
Installed and
Active To Not
Enabled
Active State**
•
You may create,
edit, or delete
mappings.
•
You may edit
QAM channel
settings.
B
De-activate
Mappings.
128