Motorola APEX1000 Installation And Operation Manual page 137

Window Section
GigE Interface
Settings
(Continued)
Interface
Redundancy
Global
Help Button
Configuration • GigE Configuration
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
Definition/Range
UDP Ports Indicates the number of UDP ports currently opened. You can
Open
change the IP and Subnet only if the UDP Ports Open value
equals 0.
Number Input
Indicates the number of input streams currently assigned to an
TS interface. Input streams are assigned when a mapping is added to
the APEX. This indicates whether or not an interface is in use.
Caution: You cannot change the IP address, subnet mask, and
Enabled settings if there are any input streams assigned to an
interface.
IGMP Version Shows the Internet Group Management Protocol version.
Default Shows the IP address of the default gateway for GigE 1/2 and GigE
Gateway
3/4.
Enable Enables or disables GigE interface redundancy.
Interface
Interface Redundancy is based on GigE link status. Loss of link will
Redundancy
cause an interface to failover to the backup.
Suspend Enables or disables Suspend Failover (prevents failovers to or from
Failover
the backup interface).
Range: Enabled/Disabled (default)
Force Failover
Initiates a force failover from one GigE interface to the other.
Button
Note: Force failover overrides the Suspend Failover setting.
Status
Read–only display. Indicates whether GigE interface redundancy is
enabled or disabled.
Enable Auto-
Enables or disables Auto-Switchback to the primary GigE interface
Switchback (when the primary interface is back online).
Auto-
This is the period of time (in seconds) to wait before switching back.
Switchback
Period (s)
Failover Alarm Occurs when a primary GigE interface has failed over to the backup
GigE interface, or the user has initiated a force failover from the
primary GigE interface.
Available in selected windows. Click to view corresponding help topics.
B
119