Table of Contents
Advertisement
EAS Configuration
The EAS Configuration window controls the configuration of SCTE 18 Emergency Alert
System messages. You can enable or disable the reception and insertion of EAS
messages. Additionally, you can configure the Input Ethernet interface, Multicast and
Source IP addresses, and the UDP port on which to receive the messages.
The Status section provides a count of the EAS messages received, as well as a count of
Invalid EAS Messages:
CAUTION
The EAS PID (0x1FFB) is not inserted if the output has been configured for pass-through
mode, or if a user ancillary-mapped another PID to PID 0x1FFB.
Configuration • EAS Configuration
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
Figure 6-10 — EAS Configuration
B
95
Advertisement
Table of Contents
