Output Ts Configuration - Motorola APEX1000 Installation And Operation Manual

Item
MC EMM Insertion Mode
st
1 EMM PID (Hex)
nd
2 EMM PID (Hex)
Status

Output TS Configuration

The APEX1000 does not allow editing or adding service routes, or changing QAM
channel configuration settings, associated with uninstalled or disabled QAM channels.
Note: You can delete existing service routes on uninstalled or disabled QAM channels,
but the APEX1000 does not allow you to make any changes to these service routings
until the output QAM is installed and enabled.
Session Controlled mappings always require an active QAM channel (entitled and
installed). This is necessary to immediately alert the SDV manager when a service
mapping is not possible (considered to be failed).
The following table shows the various actions taken when performing service mappings:
Configuration • Output TS Configuration
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
MC Insertion tab field definitions
Definition/Range
Configures the MediaCipher encryption mode.
Values are:
Out Of Band — The APEX does not add any specific descriptor referring
to entitlement messages as they are transferred over a different
frequency.
Full In Band — The APEX adds specific descriptors in the CAT referring to
PID values allocated to EMM entitlement messages.
Default value is Out Of Band.
PID value allocated to the first MediaCipher CA_descriptor to be included
in the CAT.
Range: 0x1C00 to 0x1FFE
The default value is 0x1C02.
When checked, PID value allocated to the second MediaCipher
CA_descriptor to be included in the CAT.
Range: 0x1C00 to 0x1FFE
The default value is 0x1C03.
Caution: To prevent PID collisions when performing EMM PIDs
configuration, be mindful of the PID assigned to other stream components,
such as VCT (0x1C00), SNT (0x1C01), or background services.
Opens the RDS Status window.
B
127