Motorola APEX1000 Installation And Operation Manual page 186

Item
Index
Input Interface
Input UDP
Input Multicast IP
Input Source
In Use
Input Program
Output Program
TS:QAM
Bandwidth (Mbps)
Manager IP
Session ID
Display Range
SDV — Switched Digital Video Controls • RTSP Controller Configuration
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
RTSP Status window field definitions
Definition
Displays the index of input transport streams.
Range: 1 – 768
Specifies a GigE port (1 – 4) as the input interface.
Identifies the input UDP port for a service (UDP port opened to
receive service).
Displays the Multicast receive IP address:
•
Valid Range: 224.0.1.0 – 239.255.255.255
•
Reserved: 224.0.0.0 – 224.0.0.255
•
Not used: 0.0.0.0
This is the IP address of the source device for multicast reception.
The source IP address must be a valid singlecast address.
Shows whether the Primary and/or Secondary are currently in use.
Identifies the input MPEG program number for the transport stream
(0 – 65535).
Input Program No. 0 is used as a wild card program, and informs the
APEX1000 to map the first service listed in the input PAT message
to the specified output.
The Output Program Number (1 – 65535).
The Output Transport Stream number and Output QAM channel.
The Expected Program Bandwidth (Mbps). This is the bandwidth of
the program as defined in the service mapping.
Note: A value of 0 indicates that the program BW is unknown.
Displays the IP address of the manager.
Session ID established between the APEX1000 and the manager.
Session IDs are stored as three 4-byte words.
Displays a continuous section of the RTSP Status Table, 32 index
units at a time.
Range: 1 – 768
B
168